Table of Contents
Advertisement
Chapter 2. Hardware Setup
The power outlet permission will then be assigned to the port you selected.
Hot Plugging
Dual Rail LCD Over-IP KVM Switch support hot plugging – components can
be removed and added back into the installation by unplugging and replugging
cables from the ports without the need to shut the unit down.
Note: If the server's Operating System does not support hot plugging, this
function may not work properly.
The Adapter ID Function
Adapter Cable information (the Adapter ID, port name, OS, keyboard
language, and access mode), is stored on the adapter. The switch's Adapter ID
function takes this information and stores it along with the adapter cable's
configuration information (access rights, etc.), in its database – so that when
you move a server together with its adapter cable from one port to another, you
don't have to reconfigure its settings – the Adapter ID function restores them
at the new location. The only change is in the port number.
When moving the server and adapter cable to another switch, however, only the
information that is stored on the adapter is retained. For the other settings you
must either reconfigure them, or use the Backup/Restore function (see
page 202) to restore them.
Since port settings are stored with the adapter, if you move a server to a new
port without its original adapter; or if you connect a different server to the
adapter, you must manually reconfigure the port settings for the new server.
See Sidebar Utilities, page 97 for port configuration details.
26
Advertisement
Table of Contents
