Appendix K Command Interpreter - ZyXEL Communications ZyWall 5 Series User Manual

The following describes how to use the command interpreter. Enter 24 in the main menu to
bring up the system maintenance menu. Enter 8 to go to Menu 24.8 - Command Interpreter
Mode. See the included disk or zyxel.com for more detailed information on these commands.
Note: Use of undocumented commands or misconfiguration can damage the unit and
possibly render it unusable.
Command Syntax
• The command keywords are in courier new font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>.
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means or.
For example,
sys filter netbios config <type> <on|off>
means that you must specify the type of netbios filter and whether to turn it on or off.
Command Usage
A list of valid commands can be found by typing help or ? at the command prompt. Always
type the full command. Type exit to return to the SMT main menu when finished.
Command Examples
This section provides some examples of commands you can use on the ZyWALL. See the
other appendices for more examples.
Configuring What You Want the ZyWALL to Log
1 Use the
configure which logs the ZyWALL is to record.
2 Use
sys logs category

Appendix K Command Interpreter

command to load the log setting buffer that allows you to
sys logs load
to view a list of the log categories.
ZyWALL 5/35/70 Series User's Guide
A
P P E N D I X
Command Interpreter
K
799