F/W Upload Screen; Figure 295 Maintenance > Firmware Upload; Table 195 Maintenance > Firmware Upload - ZyXEL Communications ZyWall 5 Series User Manual

Internet security appliance

Hide thumbs Also See for ZyWall 5 Series:

Table of Contents

ZyWALL 5/35/70 Series User's Guide

Table 194 MAINTENANCE > Device Mode (Bridge Mode) (continued)

31.10 F/W Upload Screen

Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a

.bin extension, for example, "zywall.bin". The upload process uses HTTP (Hypertext Transfer

Protocol) and may take up to two minutes. After a successful upload, the system will reboot.

Section 47.5 on page 672

Click MAINTENANCE > F/W UPLOAD. Follow the instructions in this screen to upload

firmware to your ZyWALL.

Note: Only upload firmware for your specific model!

Figure 295 MAINTENANCE > Firmware Upload

The following table describes the labels in this screen.

Table 195 MAINTENANCE > Firmware Upload

Note: Do not turn off the ZyWALL while firmware upload is in progress!

Click Apply to save your changes back to the ZyWALL. After you click Apply,

please wait for one minute and use the IP address you configured in the LAN

Interface IP Address field to access the ZyWALL again.

Click Reset to begin configuring this screen afresh.

for upgrading firmware using FTP/TFTP commands.

Type in the location of the file you want to upload in this field or click Browse ... to find it.

Click Browse... to find the .bin file you want to upload. Remember that you must

decompress compressed (.zip) files before you can upload them.

Click Upload to begin the upload process. This process may take up to two minutes.

Chapter 31 Maintenance

Zywall 70 series Zywall 35 series