Figure 80 Network > Dmz > Ip Alias; Table 48 Network > Dmz > Ip Alias - ZyXEL Communications ZyWall 5 Series User Manual

ZyWALL 5/35/70 Series User's Guide
The ZyWALL has a single DMZ interface. Even though more than one of ports 1~4 may be in
the DMZ port role, they are all still part of a single physical Ethernet interface and all use the
same IP address.
The ZyWALL supports three logical DMZ interfaces via its single physical DMZ Ethernet
interface. The ZyWALL itself is the gateway for each of the logical DMZ networks.
The IP alias IP addresses can be either private or public regardless of whether the physical
DMZ interface is set to use a private or public IP address. Use NAT if you want to make DMZ
computers with private IP addresses publicly accessible (see
information). When you use IP alias, you can have the DMZ use both public and private IP
addresses at the same time.
Note: Make sure that the subnets of the logical networks do not overlap.
To change your ZyWALL's IP alias settings, click NETWORK > DMZ > IP Alias. The
screen appears as shown.
Figure 80 NETWORK > DMZ > IP Alias
The following table describes the labels in this screen.
Table 48 NETWORK > DMZ > IP Alias
LABEL
Enable IP Alias 1,
2
IP Address
184
DESCRIPTION
Select the check box to configure another DMZ network for the ZyWALL.
Enter the IP address of your ZyWALL in dotted decimal notation.
Note: Make sure the IP addresses of the LAN, WAN, WLAN and
DMZ are on separate subnets.
Chapter 21 on page 395
Chapter 9 DMZ Screens
for more