Installing The Icp-Com-If Relay Module - Bosch ICP-MAP5000-2 Installation Manual

36 en | Installation
Ferrite core
2.13

Installing the ICP-COM-IF relay module

The ICP-COM-IF relay module can be mounted on the hinged mounting plate or the mounting
rails of the MAP control panel enclosure.
A clearance of approx. 15 mm is required on either side for subsequent wiring. The terminal
plugs can be unplugged laterally.
1.
2.
2016.06 | 17 | F.01U.168.332
Attach the carrier plate of the ICP-COM-IF relay module in the holes provided in the
hinged mounting plate or the mounting rails.
Use the screw provided to secure the carrier plate to the bottom rail.
Installation manual
MAP 5000
Bosch Sicherheitssysteme GmbH