Panasonic MINAS S-series Operating Manual page 49

Set the rotary switch to
default "0" position
for GAIN adjustment.
CN I/F
CN SIG
CN MOTOR
2.Check LED status.
LED color
Green Main power is on. Amplifier power is on.
Orange Flashing when warning occurs. (Overload, excessive regenerative energy)
Red Alarm
Make sure that the alarm code LED is not flashing.
(Under the normal operation, the alarm indicator is OFF.)
This indicator will start flashing when an alarm occurs.
Alarm codes (see page 60-65) are indicated by the number of flash
(in orange and red)
Orange: Tens digits, Red: Unit digits
(Example)
When an overload (alarm code No.16) occurs:
The alarm indicator will flash in orange once and in red six times.
1 sec. 0.5 sec. 0.5 sec.
orange red red
1 sec. 0.5 sec. 0.5 sec.
3. Set Parameters.
Prepare a personal computer and PANATERM
4. Input commands relevant to
the desirable control mode.
- 49 -
Meaning
0.5 sec. 0.5 sec. 0.5 sec.
red red red
0.5 sec. 0.5 sec. 0.5 sec.
After
red
2
0.5 sec.
seconds
.
®