Panasonic MINAS S-series Operating Manual page 119

External Regenerative Discharge Resistor
P r o d u c t
Part.No.
n u m b e r
DV0P2890 4 5 M 0 3
DV0P2891 4 5 M 0 3
Manufacturer: IWAKI MUSEN KENKYUSHO CO., LTD
< N o t e s >
For safety, a thermal fuse is built in the optional external regenerative discharge
resistor. Wiring to the internal thermal fuse may break depending on the applicable
heat radiating conditions, operating temperature range, supply voltage and load fluc-
t u a t i o n .
Be sure to assemble the amplifier with the machine and check the operating limit so
that the surface temperature of the regenerative discharge resistor may be 100Åé or
lower on poor conditions likely to cause generation of regenerative discharge resis-
tance (such as high supply voltage, large load inertia and short deceleration time).
Recommended combination between amplifier and
external regenerative discharge resistor
Amplifier
Single-phase 100V
type
1
DVOP2890
2
x 1
3
< N o t e s >
Regenerative discharge resistor reaches high temperature.
Device measures to avoid fire and burns.
When mounting the amplifier, do not install near flammables.
Do not install in a place reached by hand.
Specifications
R e s i s t a n c e Rated power Built-in thermal fuse operating temperature
50 Ω 1 0 W
100 Ω 1 0 W
Power supply
Single phase/Three-phase 200V
DVOP2891
x 1
- App.45 -
130 ±2 °C
130 ±2 °C
For amplifier types, see pages 10
and 11.