System Interface Port - Fujitsu Stylistic 2300 Technical Reference Manual

System Interface Port

The system interface port on the Stylistic 2300 pen tablet allows you to attach the Stylistic 1200 port
replicator. The connector used for the system interface port is manufactured by:
I-PEX Co. Ltd.
4-7-10, Haramachida
Machida City, Tokyo, Japan
Phone 0427-29-1670, Fax 0427-29-1671
The following are vendor part numbers for the connectors on the system interface port:
• CT-30001-120T-IPEX (connector on pen tablet)
• CT-30002-120T-IPEX (connector on port replicator)
The system interface port is a 120-pin connector. Figure 6-1 shows the pin locations for the system
interface port connector on the pen tablet.
Figure 6-1 System Interface Port Connector (On Pen Tablet)
Position 120
Position 119
The pin assignments for the system interface port connector on the pen tablet are given in Table 6-9.
Signals designated with the "pound" (#) symbol are active low.
Note: • Signal names listed in the second column of this table are not industry standard signal names. They
are provided to assist in cross-referencing these signal names when they appear elsewhere.
• Signals provided on the system interface port duplicate signals for connectors on the pen tablet. Do not
use peripheral connectors on the pen tablet when using corresponding interfaces on the system
interface port.
• When the port replicator is connected, the USB port on the pen tablet is disabled.
6-8 Peripheral Interfaces
Position 4
Position 2
Position 1
Position 3
Microsoft Corp. Exhibit 1020