Recovering The Disk Image - Fujitsu Stylistic 2300 Technical Reference Manual

Appendix B

Recovering the Disk Image

A recovery utility for the Stylistic 2300 pen tablet allows you to reinstall the disk image, including the
operating system on the pen tablet's internal hard disk. You can use this utility to restore the image on the
internal hard disk drive from the product recovery CD. This is necessary when the internal hard disk is
replaced with a blank hard disk or when system software on the hard disk becomes so corrupt as to
render the system unusable.
Note: Recovering the disk image from the product recovery CD will erase the entire hard disk drive. Any
application software that has been installed on the system since it was shipped from the factory must be
reinstalled after performing this procedure. If possible, back up any valuable data on the hard disk drive
before recovering the disk image.
The recovery utility, Dsk2300 is distributed on the Fujitsu Recovery CD Utility 2300 floppy diskette
shipped with each pen tablet system along with the product recovery CD which contains the disk image
for the system's hard disk drive.
The following software and hardware is required before you can use Dsk2300 to recover the operating
system on your pen tablet:
• The appropriate product recovery CD for the pen tablet.
There are different product recovery CDs for the Stylistic 2300 pen tablet depending on the operating
system, the size of the pen tablet's hard disk, and the language version of the operating system. The
product recovery CD shipped with the pen tablet is the US English version with a disk image file that
matches the original operating system and the size of the original hard disk. Product recovery CDs for
other languages (French, German, Italian, and Spanish) must be ordered separately.
• The Fujitsu Recovery CD Utility 2300 floppy diskette.
• An external floppy disk drive (Fujitsu model FMWFD2).
• An external CD-ROM drive.
• Drivers for your CD-ROM drive for MS-DOS are required if your CD-ROM drive does not use a PC
Card interface. If required, add your CD-ROM drivers to the Fujitsu Recovery CD Utility 2300 floppy
diskette and modify the CONFIG.SYS and/or AUTOEXEC.BAT files on the diskette to load your
CD-ROM drivers.
Note that Phoenix Card Manager Plus (PCM Plus) drivers are preinstalled on the Fujitsu Recovery CD
Utility 2300 floppy diskette to provide socket services for CD-ROM drives that use a PC Card
interface.
To run Dsk2300,
1. Connect your floppy disk drive and CD-ROM drive to the pen tablet.
2. Boot the pen tablet from the Fujitsu Recovery CD Utility 2300 floppy diskette.
3. Load the device drivers necessary to use your CD-ROM drive under MS-DOS.
4. Insert the product recovery CD in the CD-ROM drive and look at the disk image file name on the CD.
You will need to know the file name later in this procedure. (There is only one file on the CD.)
Microsoft Corp. Exhibit 1020
B-1