Running Mfg2300; Table 3-15 Mfg2300 Parameters - Fujitsu Stylistic 2300 Technical Reference Manual

Note: If the PMSETUP.INI file is deleted, it is recreated the next time PM Setup is run. When this occurs,
default settings for all entries in PMSETUP.INI are restored.

Running MFG2300

MFG2300 is a command-line utility that allows you to configure BIOS Setup options and other options
such as access to individual BIOS Setup menus. (Note that in addition to running MFG2300 at the
command line as described here, you can run MFG2300 from a batch file to configure BIOS options to
desired settings.)
To run MFG2300 attach a keyboard and floppy disk drive to your system and perform the following
procedure. (An external keyboard must be used to type MFG2300 commands since pen support is not
available for MFG2300.)
1. Start your system from a bootable diskette.
2. Type the command MFG2300 followed by the desired parameters using the following syntax,
MFG2300 [option=setting]
where option and setting are the mnemonic symbols for the desired MFG2300 parameters listed in
Table 3-15. (Brackets indicate that the parameter is optional.) You can specify several parameters on
the same command line. To do so, place a comma between each parameter. (Do not exceed the
maximum MS-DOS command line length of 127 characters, including spaces.) For example, the
following command sets the display device to LCD and turns the speaker off.
MFG2300 DISP=LCD, SPK=N
3. When all desired options and settings are typed on the command line, press Enter to run MFG2300.
When the MFG2300 command is complete, the following message is displayed.
Configuration complete.
Table 3-15 lists MFG2300 parameters and the BIOS settings that they configure. These BIOS options are
the same as those described earlier for BIOS Setup. Refer to "BIOS Setup" earlier in this chapter for
detailed descriptions of corresponding BIOS options listed in this table.
Option Symbol Setting Symbol
QKBT N
Y
DIAG N
Y
PRMT N
Y
NLOK A
Y
N
BOOT CA
AC
3-24 Configuring the Stylistic 2300 Pen Tablet System

Table 3-15 MFG2300 Parameters

Setting Description
Disabled
Enabled
Disabled
Enabled
Disabled
Enabled
Auto
On
Off
C: then A:
A: then C:
Option Description
QuickBoot Mode
Boot-time Diagnostic
Messages
Setup Prompt
Numlock
Boot Sequence
Microsoft Corp. Exhibit 1020