Placing Originals; Placing Originals On The Original Table - Ricoh Savin en5100WD Operating Instructions Manual

1. Placing Originals

Placing Originals
This section describes the procedure for placing originals on the original table.
• Set one original at a time on the original table.
• Once an original start to feed in, do not push or pull it. This may damage the original.
• If the original's rear edge is badly curled, smooth it out with both hands before scanning. If the
original is inserted as is, it may be damaged.
• When inserting an original, push it lightly against the rollers. Pushing it with force may cause an
original jam.
• When inserting an original, be careful not to put the trailing edge into the entrance of the bypass
tray. This will cause an original jam.
• Place originals after any correction fluid or ink has completely dried. Not taking this precaution will
result in a dirtied scanning glass and blemished copies.
• Dust and residue from originals drawn with a pencil can result in a dirtied scanning glass and
blemished copies. We recommend using the carrier sheet for this type of original.

Placing Originals on the Original Table

Place originals on the original table.
1. Make sure "Ready" appears on the screen.
2. Adjust the original guides to the size and orientation of the original.
Make sure the original guides are flush against the original. Do not push the original guide side
fence with force.
30
BKW001S