Power Cord - Canon DR-9080C Service Manual

VI. REGULAR
INSPECTION BY
THE USER
Instruct the user that the following locations
must be cleaned about once a week.
For the details, refer to the user's manual.
1. Exterior
Wipe the covers with a cloth tightly wrung with
water or neutral detergent soaked, and then wipe
dry.
2. Document Sensor
Take off the dusts gathered on the document
sensors with a blower or equivalent.
3. Reading glass
Wipe the reading glass (Upper, Lower) with a
cloth tightly wrung with water and then wipe dry.
4. Feeder Assembly
Wipe the following rollers with a cloth tightly
wrung with water and then wipe dry:
1) Pick-up roller
2) Feed roller
3) Retard roller
4) Platen roller
5) Feeder roller
COPYRIGHT © 2003 CANON ELECTRONICS INC. CANON DR-6080/9080C FIRST EDITION OCT. 2003
CHAPTER 1 GENERAL DESCRIPTION CHAPTER 1 General Description
5. Cleaning of Shading plates
Even when the reading glass and the rollers
are cleaned, if the scanned image is streaked, the
shading plate may be stained.
Wipe the shading plates (Upper, Lower) with
a cloth tightly wrung with water and then wipe dry.
Note: Since the machine is being turned ON, be
careful to proceed the work. And, take care
so that the shading plates may not
creased.

6. Power Cord

After the power cord is plugged in to the outlet
for a long period of time, dust will collect on the
connected part and could cause a fire or electric
shocks. To prevent this, clean it regularly.
7. Imprinter (guide plate)
If ink adheres to the guide plate located in the
inner part of the imprinter, it may contaminate the
document during scanning operation. Wipe the
guide plate with a cloth tightly wrung with water or
neutral detergent soaked, and then wipe dry. To
prevent this, clean it regularly.
8. Imprinter (ink cartridge)
Wipe softly the ink adhered to the ink nozzle
of the ink cartridges with a lint-free cloth or paper
(A cotton-tipped swab is also acceptable). Be
careful not to wipe or touch the electrical contact
part when wiping the ink.
1 - 13