Canon DR-9080C Service Manual page 112

CHAPTER 3 DISASSEMBLY & REASSEMBLY
10. Front platen roller
1) Detach the right/left cover assembly.
2) Detach the lower registration roller.
3) Open or dismount the upper unit.
4) Remove two screws
detach the platen unit
the arrow. Unhook the connector
Screw
Platen unit
Connector
Fig. 3-322
3 - 30
located inside and
in the direction of
.
COPYRIGHT © 2003 CANON ELECTRONICS INC. CANON DR-6080/9080C FIRST EDITION OCT. 2003
5) Remove two E-rings
and two bearings
detach the front platen roller. And then,
remove two spacers
the pin , and the gear
Note: The spacer comes with the bearing.
E-ring
Back platen roller
Pin
Fig. 3-323
(one on each side)
(one on each side) to
(one on each side),
.
Bearing
Spacer
Gear