Canon DR-9080C Service Manual page 164

CHAPTER 5 TROUBLESHOOTING
f) Solenoids
Fig. 5-314 shows the part of the Operation
window corresponding to the solenoids. The
Pick-up Solenoid
(registration clutch) will pull in with the
selected force (Weak, Middle, or Strong) when
it is selected (See Fig. 5-315). When STOP is
selected, each solenoid will stop pulling in.
Fig. 5-314
Fig. 5-315
Note: For the solenoid force level , select Weak
or Middle, and stop the solenoid as soon
as you have checked its operation.
5 - 14
and Clutch Solenoid
COPYRIGHT © 2003 CANON ELECTRONICS INC. CANON DR-6080/9080C FIRST EDITION OCT. 2003
g) Shading plate
Fig. 5-316 shows the part of the Operation
window corresponding to the shading plates.
Shading plates on the upper or lower side will
pop up via a gear to overhang the platen roller,
as soon as any force (Weak, Middle, and
Strong) is selected (See Fig. 5-317), because
the upper or lower shading solenoids are
pulled in.
When STOP is selected, both shading plates
will return to their original positions.
Fig. 5-316
Fig. 5-317
Note 1: When operating the shading plates,
select Weak or Middle, and stop the
operation as soon as you have checked it.
Note 2: Confirming the operation of the shading
plates is enabled even when cleaning the
shading plates.