Configuring Advanced Filtering Options - Avaya 3.7 Configuration Manual

Note:
A packet is filtered against the ACL policies defined in the ACL list in the list
Note:
order. The packet is matched against policy number 1 first, then policy number 2,
then policy number 3, and so on until the packet finds a match or it exhausts the
list. If a match is found, the VSU applies the action specified in the policy to the
packet. If no match is found, the VSU applies the default policy to the packet. The
default policy is to permit the packet.
To edit, change the sequence, or delete a filtering policy:
1. Move to the Configuration Console window.
2. From the Contents column, select the VSU where you want to modify the ACL.
3. Click the Policies tab to bring it to the front.
4. From the drop-down list, select Packet Filtering, then click GO to open the Policy Manager
for Packet Filtering.
5. From the ACL, select a specific filtering policy.
6. Use Table 11
Table 11: ACL commands
Command
Edit
Move UP
Move Down
Delete
7. When finished, click Save to save your work.

Configuring advanced filtering options

To configure advanced filtering options:
1. Move to the Configuration Console window.
2. From the Contents column, select the VSU where the new filtering policy needs to be
located.
3. Click the Policies tab to bring it to the front.
for performing specific ACL management tasks.
Description
Use this command to modify the filter policy through the
Packet Filtering Policy Wizard.
Click this button to move the filter policy higher in the
ACL.
Click this button to move the filter policy lower in the ACL.
Click this button to remove the filter policy from the ACL.
Packet Filtering
Issue 4 May 2005 191