X25 Timer Tx1; X25 Timer Tx2 - HP MSR series Command Reference Manual

x25 timer tx2

•
• x25 timer tx3

x25 timer tx1

Use x25 timer tx1 to set calling request (indication) sending timer for the DTE (or DCE).
Use undo x25 timer tx1 to restore the default.
Syntax
x25 timer tx1 seconds
undo x25 timer tx1
Default
The timer time on a DTE is 200 seconds, and that on a DCE is 180 seconds.
Views
Interface view
Default command level
2: System level
Parameters
seconds: Time of calling request (indication) sending timer, in the range of 1 to 1000 seconds.
Usage guidelines
According to X.25, a timer should be started when the DTE sends a call request (or the DCE sends a call
indication). If no peer acknowledgement is received after the timer timeout, the sending end will take
some measures to guarantee the normal proceeding of the local procedure. This parameter specifies the
time of this timer.
Examples
# Set calling request (indication) sending timer to 100 seconds on the X.25 interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer tx1 100
Related commands
x25 timer tx0
•
• x25 timer tx2
x25 timer tx3
•
x25 timer tx2
Use x25 timer tx2 to set the reset request (indication) timer for DTE (or DCE).
Use undo x25 timer tx2 to restore the default.
Syntax
x25 timer tx2 seconds
undo x25 timer tx2
379