HP MSR series Command Reference Manual page 154

MFR4 current state: UP
Line protocol current state: UP
Description: MFR4 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet Address is 12.12.12.2/16 Primary
Link layer protocol is FR IETF
LMI DLCI is 0, LMI type is Q.933a, frame relay DTE
LMI status enquiry sent 435, LMI status received 435
LMI status timeout 0, LMI message discarded 0
Physical is MFR
Output queue: (Urgent queue: Size/Length/Discards) 0/50/0
Output queue: (Protocol queue: Size/Length/Discards) 0/500/0
Output queue: (FIFO queuing: Size/Length/Discards) 0/75/0
Last clearing of counters:
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
1058 packets input, 832389 bytes, 0 drops
619 packets output, 828190 bytes, 0 drops
# Display brief information about interface MFR 4.
<Sysname> display interface mfr 4 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
MFR4
# Display the brief information of all MFR interfaces in the DOWN state.
<Sysname> display interface mfr brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface
MFR1
Table 28 Command output
Field
current state
Line protocol current state
Description
The Maximum Transmit Unit is 1500
Never
Link Protocol Main IP
UP UP(s) --
Link Cause
DOWN Not connected
142
Description
Description
Physical layer state of the MFR interface:
•
DOWN (Administratively)—The interface has been
shut down with the shutdown command.
•
DOWN—The interface is physically down but
administratively up.
•
UP—The interface is both administratively and
physically up.
Link layer state of the MFR interface:
•
DOWN—The link layer of the interface is down.
•
UP—The link layer of the interface is up.
Interface description.
MTU.