Table of Contents
Advertisement
Using the mastering equalizer
1. When the
screen is displayed, press the F1
Mastering
(
) button to open the
EQ
EQUALIZER
Mastering equalization is set on this screen.
2. Adjust mastering equalization on this screen.
The equalizer parameters are as follows.
GAIN
High gain
Setting range: ±12dB
HIGH
(Default: 0dB)
Mid gain
MID
Setting range: ±12dB
(Default: 0dB)
Low gain
LOW
Setting range: ±12dB
(Default: 0dB)
Use the HIGH, MID, and LOW GAIN knobs to adjust the
gain.
Use the HIGH, MID, and LOW FREQ knobs to adjust the
center frequency.
Use the MID Q knob to set the MID FREQ bandwidth.
Setting range:
to
0.25
16
You use the EQUALIZER ON/OFF button to turn the
equalizer on/off.
NOTE
Q refers to the center frequency of the equalizer divided by
the bandwidth. A high Q value reduces the cut and/or boost
applied to the frequencies. Depending on the equalizer
settings, the graph at the top of the screen changes.
3. After making the settings, press the F1 (g) button to return
to the
screen.
Mastering
4. The
item state of the
EQ
Mastering
or
.
ON
OFF
10 - Mixing Down and Mastering Tracks
screen.
FREQ
High frequency
Setting range: 1.7kHz to
18kHz (Default: 10kHz)
Mid frequency
Setting range: 32Hz to
18kHz (Default: 1.0kHz)
Low frequency
Setting range: 32Hz to
1.6kHz (Default: 100Hz)
(Default:
)
0.5
screen is shown as
Using mastering compression
You can choose between a single band and a multi-band type of
compressor.
Multi-band compressors allow independent settings for the low,
mid and high frequency ranges, so you can adjust the overall
volume balance. By using compression, you can also reduce
unwanted peaks and increase the overall gain in order to raise
the volume, creating a mastered sound with greater impact.
screen is displayed, press the F2
1. When the
Mastering
(
) button to open the
COMP
2. Press the F3 (
) button to open the library list
LIBRARY
pop-up screen.
3. Use the JOG/DATA dial or the CURSOR (5/b) buttons to
select (blue highlight) the desired library, and then press the
F4 (t) button.
After the library is read, the display returns to the
screen.
MULTI
4. When using the multi-band compressor, move the cursor
to the band display area, use the JOG/DATA dial to switch
among the bands, and then set the parameter for each band
as desired.
Multiband type
Single band type
At this time, the selected band is shown in the upper left
corner.
5. Use the CURSOR (5/b/g/t) buttons to select the item
whose value you to change, and then use the JOG/DATA
dial to change it.
screen.
COMP MULTI
COMP
59
TASCAM DP-24SD
Advertisement
Table of Contents
