Table of Contents
Advertisement
No Armed Track
No Undo History
Not Stopped
OUT point must be
set after the IN
point.
Protected Card
Recorded Track Not
Found
Revert to discard
changes.
Same Track
Song Protected
Stereo Track Full
Track Full
Trk Edit Fail
Trk Too Short
Turn off the
Guitar Effect or
use two or less
Dynamic Effects.
Virutal Track has
different Track
Type
Work Memory Full
There is no track in recording standby.
You tried to enter auto punch mode or press the RECORD button when no tracks were in record standby.
(See "Automatic punching in and out" on page 46.)
Put a track into record standby before pressing the RECORD button or entering the auto punch mode.
There is no undo history.
There are no actions to be undone. (See "Undoing an operation" on page 40.)
The recorder is not stopped.
When the recorder is not stopped, this message appears when you press a button that works only when
the recorder is stopped, such as the UNDO/REDO button, etc.
You cannot set the OUT point before the IN point. Set the OUT point after the IN point.
The inserted SD card is write-protected.
To record or edit, turn off the unit and unprotect the SD card.
During execution of the export menu, the current song has no tracks recorded in it.
No tracks are recorded in the current song, or virtual tracks are not assigned to physical tracks.
Select a recorded song, assign the track you want to export to a physical track, and then export it. (See
"Virtual tracks" on page 48.)
Editing and changes made from when loaded will be cleared, and reset to the same status as when
loaded. Proceed only when you are sure you wish to clear these changes.
The same track has been specified.
This message appears in the clone track setting, when the same track is specified.
The song is protected.
The song is protected and you are trying to change it (record, edit, etc.). (See "Protecting songs" on page
33.)
Unprotect the song.
The stereo track is already recorded.
This message appears if you try to import a stereo file when a stereo track is already recorded in the song.
The track is already recorded.
This message appears if you try to import a file when all tracks already have recordings. (See "Importing
tracks" on page 68.)
Track edit failed.
Save the song and turn the unit off and then on, and perform track edit again.
The track is too short.
You are trying to start a record in mixdown mode, but the time between the IN and OUT points is too
short. The IN and OUT points must be at least 4 seconds apart. (See "Setting IN/OUT points" on page
45.)
While using a guitar effect, the use of dynamic effects is limited to only 1–2 channels. To use dynamic
effects on 3 or more channels, turn the guitar effect OFF.
Since a virtual track has been recorded, the track type cannot be changed. If you want to change it, clear
the recorded virtual track.
The work memory is full.
Even if the SD card has enough remaining space, this error may occur when you perform many editing
operations. You may be able to continue the work if execute the
menu to increase the available space in the work memory. (See "Undoing an operation" on page 40.)
15 – Messages
item of the
DELETE UNUSED
TASCAM DP-24SD
SONG
73
Advertisement
Table of Contents
