Changing The Administrator Password; Connecting The Hipath Wireless Controller To Your Enterprise Network - Siemens HiPath C10 User Manual

Management IP Address – Specifies the new IP address for the HiPath Wireless
●
Controller's management port. Change this as appropriate for the enterprise network.
Subnet mask – Specifies the appropriate subnet mask for the IP address to separate
●
the network portion from the host portion of the address (typically 255.255.255.0)
Management Gateway – Specifies the default gateway of the network
●
Primary DNS – Specifies the primary DNS server used by the network
●
Secondary DNS – Specifies the secondary DNS server used by the network
●
11. To save your changes, click OK.
The Web connection between the computer and the HiPath Wireless Controller
>
is now lost. The IP addresses are now set to the network you defined.
4.2.1.1

Changing the administrator password

It is recommended to change your default administrator password once your system is
installed.
To change the administrator password:
1. From the main menu, click Wireless Controller Configuration. The HiPath Wireless
Controller Configuration screen appears.
2. In the left pane, click Management Users.
3. In the user_admin table, click admin.
4. In the Modify User Password box, type the new administrator password.
5. In the Modify User Confirm Password box, type the new administrator password again.
6. Click Change Password.
4.2.2 Connecting the HiPath Wireless Controller to your enterprise
network
Once you have modified the management port configuration settings, the next step is to
connect the HiPath Wireless Controller to your enterprise network.
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
Configuring the HiPath Wireless Controller
Performing the first-time setup of the HiPath Wireless Controller
hwc_startup.fm
51