5.
From the RADIUS drop-down list, select the server you want to use for MAC authentication,
and then click Use. The server's default information is displayed and a red asterisk appears
next to MAC, indicating that a server has been assigned.
The RADIUS servers are defined in the Global Settings screen. For more information, see
Section 6.8, "VNS global settings", on page 116.
6.
If applicable, to use a server that has already been used for another type of authentication
or accounting, select the server you want to use for MAC authentication, and then select
User server for MAC Authentication.
7.
In the Port box, type the port used to access the RADIUS server. The default is 1812.
8.
In the # of Retries box, type the number of times the HiPath Wireless Controller will
attempt to access the RADIUS server.
9.
In the Timeout box, type the maximum time, in seconds, that a HiPath Wireless Controller
will wait for a response from the RADIUS server before attempting again.
10. In the NAS IP Address box, type the Network Access Server (NAS) IP address.
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_vnsconfiguration.fm
Virtual Network configuration
Authentication for a VNS
149