Siemens HiPath C10 User Manual page 293

State / Process Description
Failed discovery If there are SLP issues in failed discovery, the LED display
changes.
Registration Wireless AP learns the HiPath Wireless Controller's IP
address, and can begin the Registration process
Failed Wireless AP fails to learn the HiPath Wireless Controller's
Registration IP address.
Standby 1. Wireless AP enters this state from Discovery when it
encounters an active HiPath Wireless Controller and
completes the Registration process.
2. Wireless AP enters this state from Active when it receives
a control message from the HiPath Wireless Controller to
enter this state. If the Wireless AP has any wireless device
traffic, it will drop the traffic.
Wireless AP fails to register. It will wait 5 seconds and try
again.
Firmware download from the HiPath Wireless Controller is
in progress
Active (Ready) Wireless AP has received a control message from an active
HiPath Wireless Controller to enter active or ready state. It
is ready to receive wireless traffic.
Note: The two Traffic LEDs on either side of the Status LED
display a green (blink) if there is active wireless traffic. The
left LED is for the 2.4 GHz radio. The right LED is for the 5
GHz radio.
Vulnerable time Vulnerable time interval (the HiPath Wireless Controller
interval resets to factory default if powered-off for three consecutive
times during this state). No vulnerable period when access
point is resetting to factory defaults.
Upgrading Wireless AP is upgrading its firmware
firmware
Table 22 Wireless AP system states and status LED displays
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_appendixa.fm
System states and LEDs
Wireless AP system states
LEDs
Green-orange
(alternate
blink)
Orange (blink)
Red (blink)
Green (blink)
Red (slow
blink)
Orange +
green (blink)
Green (steady)
Left: Green/Off
Center: Off/
Green
Right: Green/
Off
Center: Red/
Green
293