Siemens HiPath C10 User Manual page 87

3. Modify the Wireless AP's information:
Name – Type a unique name for the Wireless AP that identifies the Wireless AP. The
●
default value is the Wireless AP's serial number.
Description – Type comments for the wireless AP.
●
Port # – Select the Ethernet port of the controller the wireless AP is connected to.
●
Poll Timeout – Type the timeout value, in seconds, for polling the controller. The
●
default value is 10 seconds.
Poll Interval – Type the interval value, in seconds, for polling the controller. The default
●
value is 2 seconds.
Telnet Access – Select whether Telnet Access to the wireless AP is enabled or
●
disabled.
Maintain client session in event of poll failure – Select this option if the AP should
●
remain active if a link loss with the controller occurs.This option is enabled by default.
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_apstartup.fm
Configuring the wireless AP
Modifying wireless AP settings
87