Siemens HiPath C10 User Manual page 41

Overview of the Controller, Access Points and Convergence Software solution
configuration, this feature will expedite deployment, as an AP will automatically receive full
configuration (including VNS assignment) upon initial registration with the HiPath Wireless
Controller.
6. Wireless AP Configuration – Modify properties or settings of the Wireless AP, if desired.
7. Virtual Network Services (VNS) Setup – Set up one or more virtual subnetworks on the
HiPath Wireless Controller. For each VNS, configure the following:
Topology – Configure the VNS.
●
RF – Assign the Wireless APs radios to the VNS.
●
Authentication and Accounting – Configure the authentication method for the
●
wireless device user and enable the accounting method.
RAD Policy – Define filter ID values and VNS Groups
●
Filtering – Define filtering rules to control network access
●
Multicast – Define groups of IP addresses for multicast traffic
●
Privacy – Select and configure the wireless security method on the VNS.
●
QoS Policy – Configure the Qos Policy.
●
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
System Configuration Overview
hwc_intro.fm
41