Invacare TDX SP2 Service Manual page 15

8.
Loosen screws B near hub A and castor D that fix
lower beam C to chassis.
When installing, use thread locking adhesive, for
example, Loctite 242.
9.
Rotate top walking beamE so that you can reach the
screw D on the gas cylinder through the drillhole C
in battery box.
1532486-L
Fig. 6-6
10.
Remove nut C on upper beam B, D on mud guard A.
Hold screw in place.
11.
Remove nut F. Hold screw in place.
12. Push screw D towards battery box so that gas cylinder
A is separated from walking beam.
13. Push gas cylinder against battery box.
14. Raise rear axle so that gas cylinder is activated and then
retract cylinder.
15. Push gas cylinder to the rear and pull it off battery box.
Installing gas cylinder
1. Install parts in reverse order.
Replacing setting screw
• 1/4" wrench
• Two long wooden blocks, min. 14 x 14 x 30 cm
• Feeler gauge with 2 mm
Fig. 6-7
Service
15