Replacing Rear Light; Seating; Point - Invacare AVIVA RX Series Service Manual

Invacare® AVIVA™ RX series
Removing Holder
1. Remove complete headlight. See 6.13.1 Replacing
Headlight, page 63.
2. Loosen and remove nut E.
3. Remove holder D including bushing C. Do not remove
bolt A and washer B for correct re-installing of holder.
Installing Holder
1. Install parts in reverse order. Tighten nut E to 6 Nm.
2. Test all functions.

6.13.3 Replacing Rear Light

This component is not serviceable. Replace the bottom part of the rear shroud instead.

6.14 Seating

This chapter deals with the replacement of interface components between the base of the mobility device and the
corresponding seating system.
For detailed instructions on the seating system, see the service manual of the corresponding seating system.
6.14.1 Replacing Actuator/Spindle — Tilt with Fixed Pivot Point
• Flat screwdriver
• Oblong wooden block (at least 7.5 cm x 7.5 cm x 35 cm)
Removing Actuator
When removing, take care of small parts such as spacers. Put all small parts down so that they can be installed
in the correct sequence.
CAUTION!
Risk of crushing
Seat comes down when actuator is removed.
– Hold the seat in position while removing the actuator.
– Move the seat into service position and place a wooden block under the backrest, or lower it carefully to
the chassis.
64
Fig. 6-59
1654647-B