Configure Average Time And Synchronization; Timing & Sync Setup - Fluke NORMA 4000 Operator's Manual

Configure Average Time and Synchronization

This configuration concerns important parameters required for the synchronization of the
measuring procedure. To configure these parameters, proceed as follows:
Timing & Sync Setup
Move the cursor to menu item Timing & Sync Setup and press Enter.
The "Timing & Sync Setup" menu is displayed. The value in column Tavg[s] is
highlighted.
Shop for Power Metering products online at:
4. Save the configuration settings by pressing the SAVE function key.
5. Press Esc to leave the entry field without changing the setting.
The default address is 0.0.0.0 (factory settings). Addresses can only be
entered in conjunction with IP network addressing (for example, address
193.0.255.4).
Network addresses are available from your network administrator.
•
Call up "Timing & Sync" Setup
•
Enter average time
•
Select synchronization source
•
Set trigger level
•
Select slope direction
•
Select low-pass filter
•
Configure signal output
www.

Configure Average Time and Synchronization

Note
Note
PowerMeterStore
Configuration
esn020.gif
1.877.766.5412
.com
7
7-9