Load Configuration; Load Configuration (Optional); Modify Loaded Configurations; Configure Method - Fluke NORMA 4000 Operator's Manual

Power
Hide thumbs Also See for NORMA 4000:
Table of Contents

Advertisement

Load Configuration

Load Configuration (Optional)

Modify Loaded Configurations

To modify the loaded configuration, proceed as described in the following sections.

Configure Method

Mode W3 is for standard power measurement as single phase or 3-phase. Mode W2 is for
the 2-wattmeter method (Aron or Blondel) in 3-wire/3-phase power systems. For more
details, see the different applications and connection diagrams in Chapter 7.
Phase-to-phase voltage (Pc
measurement. The "Corrected Power" is a useful value for measurement of transformer
losses. The calculation, Active Power ÷ Corrected Power, has to be done depending on
the type of the transformer by using Pc
to Pc

Configure Data Transfer to Printer and PC

If you wish to use an internal or external printer, or if you intend to connect a PC, you
must configure the parameters for the data exchange. This procedure consists of the
following steps:
Shop for Power Metering products online at:
If you have not set up and saved a new configuration before, you are
currently working with one of the predefined configurations, 1:W3 (factory
default) or 2:W2.
1. Proceed as described in Chapter 7, "Configure Data Transfer to Printer and PC."
2. Press function key LOAD.
A list showing all existing configurations is displayed.
3. Select a configuration and confirm by pressing Enter.
The name of the loaded configuration, for example, 10:USER, is displayed in
menu item General Setup. W2 configurations are marked as "User2."
Δ)
Δ
.

Configure external printer

Configure interface to PC

Configure RS232

Configure IEEE488 device address
Configure network (LAN) addresses and protocol
The actual selected interface is displayed in the Information row (see
Chapter 3, "Operating Controls and Display"):
RS → RS232, GP → IEEE488, EN → Ethernet, US → USB
www.
Note
or phase voltage (Pc
is used for transformer
Y)
Δ
or Pc
(see Chapter 10). In W2 mode, it is fixed
Y
Note
PowerMeterStore
Configuration

Load Configuration

1.877.766.5412
.com
7
7-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Norma 5000

Table of Contents