Cisco ASR 1000 Series Configuration Manual page 112

Configuring Services for WCCPv2—IPv6
Command or Action
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 Enter one of the following commands:
• ipv6 wccp [vrf vrf-name] service-number
[service-list service-access-list mode {open
| closed}]
• ipv6 wccp [vrf vrf-name] web-cache mode
{open | closed}
Example:
Device(config)# ipv6 wccp 90 service-list
120 mode closed
or
Device(config)# ipv6 wccp web-cache mode
closed
Step 4
ipv6 wccp check services all
Example:
Device(config)# ipv6 wccp check services
all
Step 5 ipv6 wccp [vrf vrf-name] {web-cache |
service-number}
Example:
Device(config)# ipv6 wccp 201
Step 6 exit
Example:
Device(config)# exit
IP Application Services Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR 1000)
104
Purpose
Enters global configuration mode.
Configures a dynamic WCCP service as closed or open.
or
Configures a web-cache service as closed or open.
When configuring the web-cache service as a closed service,
Note
you cannot specify a service access list.
When configuring a dynamic WCCP service as a closed
Note
service, you must specify a service access list.
(Optional) Enables a check of all WCCP services.
• Use this command to configure WCCP to check the other
configured services for a match and perform redirection for
those services if appropriate. The caches to which packets are
redirected can be controlled by the redirect ACL and not just
the service description.
Note The ipv6 wccp check services all command is a global
WCCP command that applies to all services and is not
associated with a single service.
Specifies the WCCP service identifier.
• You can specify the standard web-cache service or a dynamic
service number from 0 to 255.
• The maximum number of services that can be specified is 256.
Exits to privileged EXEC mode.
WCCPv2—IPv6 Support