Cisco ASR 1000 Series Configuration Manual page 110

Configuring a General WCCPv2—IPv6 Session
Command or Action
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3 ipv6 wccp [vrf vrf-name] source-interface
source-interface
Example:
Device(config)# ipv6 wccp source-interface
GigabitEthernet 0/0/0
Step 4
ipv6 wccp [ vrf vrf-name] { web-cache |
service-number} [group-address group-address] [
redirect-list access-list] [ group-list access-list] [
password password [ 0 | 7 ] ]
Example:
Device(config)# ipv6 wccp web-cache password
password1
Step 5
interface type number
Example:
Device(config)# interface GigabitEthernet 0/0/0
Step 6 ipv6 wccp [vrf vrf-name] {web-cache | service-number}
redirect {out | in}
Example:
Device(config-if)# ipv6 wccp web-cache redirect
in
Step 7 exit
Example:
Device(config-if)# exit
IP Application Services Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR 1000)
102
Purpose
• Enter your password if prompted.
Enters global configuration mode.
Configures a preferred WCCP router ID.
Specifies a web-cache or dynamic service to enable on the
router, specifies a VRF-name to associate with the service
group, specifies the IP multicast address used by the service
group, specifies any access lists to use, specifies whether to
use MD5 authentication, and enables the WCCP service.
Targets an interface number for which the web cache service
will run, and enters interface configuration mode.
Enables packet redirection on an outbound or inbound
interface using WCCP.
• As indicated by the out and in keyword options,
redirection can be specified for outbound interfaces or
inbound interfaces.
Exits interface configuration mode.
WCCPv2—IPv6 Support