The Upnp Screen; The Ipv6 Lan Setup Screen - ZyXEL Communications AMG1312-T10D User Manual

Chapter 7 Home Networking
Table 28 Network Setting > Home Networking > IP Alias
LABEL
Subnet
Mask
Apply
Cancel

7.5 The UPnP Screen

Universal Plug and Play (UPnP) is a distributed, open networking standard that uses TCP/IP for
simple peer-to-peer network connectivity between devices. A UPnP device can dynamically join a
network, obtain an IP address, convey its capabilities and learn about other devices on the network.
In turn, a device can leave a network smoothly and automatically when it is no longer in use.
See page 92
Use the following screen to configure the UPnP settings on your Device. Click Network Setting >
Home Networking > Static DHCP > UPnP to display the screen shown next.
Figure 47 Network Setting > Home Networking > UPnP
The following table describes the labels in this screen.
Table 29 Network Settings > Home Networking > UPnP
LABEL
UPnP
Apply
Cancel

7.6 The IPv6 LAN Setup Screen

Use this screen to configure the IPv6 settings for your Device's LAN interface.
82
DESCRIPTION
Your Device will automatically calculate the subnet mask based on the IP address that you
assign. Unless you are implementing subnetting, use the subnet mask computed by the Device.
Click this to save your changes.
Click this to restore your previously saved settings.
for more information on UPnP.
DESCRIPTION
Select Enable to activate UPnP. Be aware that anyone could use a UPnP application to
open the web configurator's login screen without entering the Device's IP address
(although you must still enter the password to access the web configurator).
Click Apply to save your changes.
Click this to restore your previously saved settings.
AMG1312-T10D User's Guide