Ipv6 Static Route Edit - ZyXEL Communications AMG1312-T10D User Manual

Chapter 8 Static Route
Table 36 Network Setting > Static Route > IPv6 Static Route (continued)
LABEL
Device
Modify

8.3.1 IPv6 Static Route Edit

Use this screen to configure the required information for an IPv6 static route. Click Add New
Static Route or select an IPv6 static route index number and click Edit. The screen shown next
appears.
Figure 73 Network Setting > Static Route > IPv6 Static Route: Add/Edit
The following table describes the labels in this screen.
Table 37 Network Setting > Static Route > IPv6 Static Route: Add/Edit
LABEL
Destination IPv6
Address
IPv6 Prefix Length Enter the address prefix to specify how many most significant bits compose the network
Gateway IPv6
Address
Bound Interface
OK
Cancel
104
DESCRIPTION
This specifies the LAN or WAN PVC.
Click the Edit icon to go to the screen where you can set up a static route on the Device.
Click the Remove icon to remove a static route from the Device. A window displays asking
you to confirm that you want to delete the route.
DESCRIPTION
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a prefix
length of 128 in the prefix length field to force the network number to be identical to the
host ID.
address.
Enter the IPv6 address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway has a route to the
destination network and helps forward packets to their destinations. If a link local address
is used, the interface should also be specified.
If you want to forward IPv6 packets to a bound interface, select the interface through
which the traffic is sent.
Click this to save your changes.
Click this to restore your previously saved settings.
AMG1312-T10D User's Guide