ZyXEL Communications AMG1312-T10D User Manual page 63

Figure 35 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 17 Network Setting > Wireless > WPS
LABEL
Enable WPS
Add a new device with WPS Method - These fields display after you enable WPS and click Apply.
Method 1 PBC
WPS
Method 2 PIN
Register
WPS Configuration Summary
AMG1312-T10D User's Guide
DESCRIPTION
Select Enable and click Apply to activate WPS on the Device.
Use this section to set up a WPS wireless network using Push Button Configuration
(PBC).
Click this button to add another WPS-enabled wireless device (within wireless range of
the Device) to your wireless network. This button may either be a physical button on
the outside of device, or a menu button similar to the WPS button on this screen.
Note: You must press the other wireless device's WPS button within two minutes of
pressing this button.
Use this section to set up a WPS wireless network by entering the PIN (Personal
Identification Number) of the client into the Device.
Enter the PIN of the device that you are setting up a WPS connection with and click
Register to authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the device's
settings.
Note: You must also activate WPS on that device within two minutes to have it present its
PIN to the Device.
Chapter 6 Wireless
63