Using The Wlan/Wps Button - ZyXEL Communications AMG1312-T10D User Manual

Configure your wireless network through the Web Configurator, or the WPS button.
Figure 2 Wireless Access Example

1.5.1 Using the WLAN/WPS Button

By default, the Device's wireless network is enabled. To turn it off, simply press the WPS/WLAN
button on top of the Device for over 5 seconds. The WLAN/WPS LED turns off.
Use the WLAN/WPS button to quickly set up a secure wireless connection between the Device and
a WPS-compatible client by adding one device at a time. To activate WPS:
With the POWER LED on steady, press the WLAN/WPS button for 1 second and release it.
1
Within two minutes, press the WPS button on a WPS-enabled client within range of the Device. The
2
WPS/WLAN LED should flash while the Device sets up a WPS connection with the client.
The WPS/WLAN LED shines green for a successful connection.
3
AMG1312-T10D User's Guide
Chapter 1 Introduction
15