National-Bit; Reset Counters Controller E3 - HP MSR series Command Reference Manual

Usage guidelines
Loopback is intended for test use. Disable loopback in other cases.
If a CE3 interface encapsulated with PPP is placed in a loopback, it is normal that the state of the link
layer protocol is reported as down.
Examples
# Enable internal loopback on interface E3 2/0.
<Sysname> system-view
[Sysname] controller e3 2/0
[Sysname-E3 2/0] loopback local

national-bit

Use national-bit to configure the national bit on the CE3 interface.
Use undo national-bit to restore the default.
Syntax
national-bit { 0 | 1 }
undo national-bit
Default
The national bit on the CE3 interface is 1.
Views
CE3 interface view
Default command level
2: System level
Parameters
0: Sets the national bit to 0 for national communication.
1: Sets the national bit to 1 for international communication.
Usage guidelines
You need to set the national bit to 0 on an E3 interface only in some special circumstances.
Examples
# Set the national bit to 0 on interface E3 2/0.
<Sysname> system-view
[Sysname] controller e3 2/0
[Sysname-E3 2/0] national-bit 0
Related commands
controller e3

reset counters controller e3

Use reset counters controller e3 to clear the controller counter of a CE3 interface.
195