Using (Ce1/Pri Interface) - HP MSR series Command Reference Manual

Syntax
reset counters controller e1 interface-number
Views
User view
Default command level
2: System level
Parameters
interface-number: Interface number.
Usage guidelines
To display the information of the controller counter, use the display controller e1 command.
The reset counters interface command clears the counters of all interfaces. To clear the controller counter
of individual CE1/PRI interfaces, use the reset counters controller e1 command.
Examples
# Clear the controller counter for CE1/PRI interface E1 2/0.
<Sysname> reset counters controller e1 2/0

using (CE1/PRI interface)

Syntax
using { ce1 | e1 }
undo using
Views
CE1/PRI interface view
Default command level
2: System level
Parameters
ce1: Sets the interface to operate in CE1/PRI mode.
e1: Sets the interface to operate in E1 mode.
Usage guidelines
A CE1/PRI interface can operate in either E1 mode (non-channelized mode) or CE1/PRI mode
(channelized mode).
In E1 mode, the interface equals a 2.048 Mbps interface without timeslot division and has the same
logical features as a synchronous serial interface. In CE1/PRI mode, the CE1/PRI interface is physically
divided into 32 timeslots numbered 0 through 31, where timeslot 0 is used for FSC. This interface can
operate as either a CE1 interface or a PRI interface.
After you set the CE1/PRI interface to operate in E1 mode, the system automatically creates a serial
interface numbered serial interface-number:0, where interface-number represents the number of the
CE1/PRI interface.
Examples
# Set CE1/PRI interface E1 2/0 to operate in E1 mode.
135