Loopback And Null Interface Configuration Commands - HP MSR series Command Reference Manual

Loopback and null interface configuration
commands
bandwidth
Use bandwidth to set the intended bandwidth for an interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
Loopback interface view, null interface view
Default command level
2: System level
Parameters
bandwidth-value: Sets the intended bandwidth in the range of 1 to 4294967295 kbps.
Usage guidelines
You can check the intended bandwidth of an interface by querying the ifspeed value of the MIB node
with third-party software.
The intended bandwidth is used by the network administrator for bandwidth monitoring, and does not
affect the actual bandwidth of the interface.
Examples
# Set the intended bandwidth to 10000 kbps for interface Loopback 1.
<Sysname> system-view
[Sysname] interface loopback 1
[Sysname-LoopBack1] bandwidth 10000
default
Use default to restore the default settings for the loopback or null interface.
Syntax
default
Views
Loopback interface view, null interface view
Default command level
2: System level
318