Error-Diffusion Restraint Enable - HP MSR series Command Reference Manual

Default
The detect timer is set to 30 seconds; the renew timer is set to 600 seconds; and the error packet
threshold 20 percent.
Views
System view
Default command level
2: System level
Parameters
detect-timer: Setting of the detect timer, in the range of 30 to 600 seconds.
renew-timer: Setting of the renew timer, in the range of 120 to 2,400 seconds.
Threshold: Error packet threshold represented by the percentage of the error packets, in the range of 5
to 100.
Usage guidelines
The setting of the renew timer cannot be less than four times of that of the detect timer, and error packets
are not counted if the total number of packets received during a period determined by the detect timer
is less than 100.
This command applies to CT1/PRI interfaces and CE1/PRI interfaces only.
The following matrix shows the command and router compatibility:
Command
error-diffusion
restraint config
Examples
# Set the detect timer to 100 seconds, the renew timer to 2400 seconds, and the error packet threshold
to 15%.
<Sysname> system-view
[Sysname] error-diffusion restraint cofing 100 2400 15

error-diffusion restraint enable

Use error-diffusion restraint enable to enable error packet diffusion restraint.
Use undo error-diffusion restraint enable to disable error packet diffusion restraint.
Syntax
error-diffusion restraint enable
undo error-diffusion restraint enable
Default
The function is disabled.
Views
System view
MSR
MSR93X MSR20-1X
900
No No No
MSR20
No
147
MSR30 MSR50
Yes Yes
MSR1000
Yes