Reset Counters Controller T1 - HP MSR series Command Reference Manual

Default
No PRI set is created.
Views
CT1/PRI interface view
Default command level
2: System level
Parameters
list: Specifies timeslots to be bundled. Timeslots are numbered 1 through 24. You can specify a single
timeslot by specifying a number, a range of timeslots by specifying a range in the form of
number1-number2, or several discrete timeslots by specifying number1, number2-number3.
Usage guidelines
When you create a PRI set on a CT1/PRI interface, timeslot 24 is the D channel for transmitting signaling,
and it cannot form a bundle that includes itself only. The attempts to bundle only timeslot 24 will fail.
In the created PRI set, timeslot 24 is used as D channel for signaling transmission, and the other timeslots
as B channels for data transmission. You can randomly bundle these timeslots into a PRI set (as the D
channel, timeslot 24 is automatically bundled). If no timeslot is specified, all timeslots are bundled into
an interface similar to an ISDN PRI interface in the form of 23B+D.
For the PRI set, the system automatically creates a serial interface that is logically equivalent to an ISDN
PRI interface. The serial interface is named in the form of serial number:23, where number is the number
of the CT1/PRI interface on which the serial interface is created.
Because a channel set and a PRI set cannot coexist on a CT1/PRI interface, your PRI set creation attempt
will fail if the channel-set command is configured.
Examples
# Bundle timeslots 1, 2, and 8 through 12 into a PRI set on CT1/PRI interface T1 2/0.
<Sysname> system-view
[Sysname] controller t1 2/0
[Sysname-T1 2/0] pri-set timeslot-list 1,2,8-12

reset counters controller t1

Use reset counters controller t1 to clear the controller counter for a CT1/PRI interface.
Syntax
reset counters controller t1 interface-number
Views
User view
Default command level
2: System level
Parameters
interface-number: Interface number.
Usage guidelines
To display the value of the controller counter, use the display controller t1 command.
154