E1 Shutdown; E1 Unframed - HP MSR series Command Reference Manual

e1 shutdown

Use e1 shutdown to shut down an E1 line on the CE3 interface.
Use undo e1 shutdown to restore the default.
Syntax
e1 line-number shutdown
undo e1 line-number shutdown
Default
E1 lines are up.
Views
CE3 interface view
Default command level
2: System level
Parameters
line-number: E1 line number in the range of 1 to 16.
Usage guidelines
This command affects not only the specified E1 line but also the serial interfaces formed by E1 line
bundling. Performing the e1 shutdown command on the specified E1 line shuts down all these serial
interfaces. Data transmission and receiving stop as a result. Likewise, performing the undo e1 shutdown
command restarts all these serial interfaces.
Examples
# Shut down the first E1 line on interface E3 2/0.
<Sysname> system-view
[Sysname] controller e3 2/0
[Sysname-E3 2/0] e1 1 shutdown

e1 unframed

Use e1 unframed to set an E1 line on the CE3 interface to operate in unframed mode (E1 mode).
Use undo e1 unframed to restore the default.
Syntax
e1 line-number unframed
undo e1 line-number unframed
Default
An E1 line operates in framed mode (CE1 mode).
Views
CE3 interface view
Default command level
2: System level
192