Battery - Barnes & Noble nook User Manual

Media Scanning After a microSD Card Change
If you turn your nook completely off before inserting, removing, or changing the microSD card
(as recommended), then when your nook turns on, it scans the microSD card to look for
changes and updates the library catalog accordingly.
If you inserted, removed, or changed the microSD card with the device on or sleeping, this
media scan does not happen.
To cause it to happen, do either of the following:
Turn your nook off (completely; not just sleep) and then turn it on again.

Attach your nook to a personal computer using the USB cable and choose Mass Storage

Mode. Then detach your nook from the personal computer.

Battery

You do not install the battery. It is pre-installed and permanently installed. It should last for
years.
Replacing the Battery
If necessary, the battery can be replaced. A replacement battery must be of the following type:
Barnes & Noble Lithium Polymer battery
Model Number BNRB1530
Rating: 3.7V, 1530mAh, 5.66Wh
You will need a small Phillips head screw driver (size 0 or 00). To replace the battery:
1 Unplug your nook from the wall charger or USB cable.
2 Turn off your nook.
3 Carefully remove the back. Full instructions for that are given in the section "Removing the
Back Cover."
4 With the back facing you, turn the nook so that the top is directed away from you. The
screw and tab holding the battery in place are at the top of the battery.
nook User Guide 28