Throttle position sensor screw
3.5 Nm (0.35 m·kgf, 2.5 ft·lbf)
2
▲
▲▲▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
EAS1TP1045
REMOVING THE INTAKE MANIFOLD
ASSEMBLY
1. Remove:
• Intake manifold assembly
TIP
Remove the rear cylinder intake manifold joint
together with the intake manifold assembly.
EAS1TP1046
INSTALLING THE INTAKE MANIFOLD
ASSEMBLY
1. Install:
• Intake manifold assembly
▼
▼▼▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
a. Install the front cylinder intake manifold joint
"1" to the front cylinder head.
Front cylinder intake manifold
joint bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Install the front cylinder intake manifold joint with
its projection "a" facing up as shown in the illus-
tration.
a
b. Install the rear cylinder intake manifold joint
"2" to the intake manifold assembly.
1
2
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲▲▲
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼▼▼
1
6-12
THROTTLE BODIES
TIP
Be sure to fit the projection "b" on the intake
manifold assembly between the projections "c"
on the rear cylinder intake manifold joint.
c. Install the intake manifold assembly.
Rear cylinder intake manifold
joint bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
• Lubricate the rear cylinder intake manifold joint
and rear cylinder head mating surfaces with
engine oil.
• Position the intake manifold assembly "3" as
shown in the illustration, and then rotate it in
the direction of the arrow shown to install it.
3
▲
▲▲▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
c
2
b
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲▲▲