Checking The Rear Brake Caliper; Assembling The Rear Brake Caliper; Installing The Rear Brake Caliper - Yamaha STAR XVS95CE 2DX1 2014 Service Manual

EWA13550
WARNING
• Cover the brake caliper piston with a rag.
Be careful not to get injured when the pis-
ton is expelled from the brake caliper.
• Never try to pry out the brake caliper pis-
ton.
a
b. Remove the brake caliper piston dust seal
and brake caliper piston seal.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS22640

CHECKING THE REAR BRAKE CALIPER

Recommended brake component replace-
ment schedule
Brake pads
Piston dust seal
Piston seal
Brake hose
Brake fluid
1. Check:
• Brake caliper piston "1"
Rust/scratches/wear → Replace the brake
caliper piston.
• Brake caliper cylinder "2"
Scratches/wear → Replace the brake caliper
assembly.
• Brake caliper body "3"
Cracks/damage → Replace the brake caliper
assembly.
• Brake fluid delivery passages
(brake caliper body)
Obstruction → Blow out with compressed air.
EWA1TP1006
WARNING
Whenever a brake caliper is disassembled,
replace the brake caliper piston dust seal
and brake caliper piston seal.
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
If necessary
Every two years
Every two years
Every four years
Every two years and
whenever the brake
is disassembled
4-43
2
EAS22650

ASSEMBLING THE REAR BRAKE CALIPER

EWA1TP1007
WARNING
• Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
• Never use solvents on internal brake com-
ponents as they will cause the brake caliper
piston dust seal and brake caliper piston
seal to swell and distort.
• Whenever a brake caliper is disassembled,
replace the brake caliper piston dust seal
and brake caliper piston seal.
Specified brake fluid
DOT 4
EAS22670

INSTALLING THE REAR BRAKE CALIPER

1. Install:
• Rear brake caliper "1"
(temporarily)
• Brake hose gaskets
• Rear brake hose "2"
• Rear brake hose union bolt "3"
Rear brake hose union bolt
30 Nm (3.0 m·kgf, 22 ft·lbf)
EWA13530
WARNING
Proper brake hose routing is essential to in-
sure safe vehicle operation. Refer to "CABLE
ROUTING" on page 2-39.
ECA14170
NOTICE
When installing the brake hose onto the
brake caliper "1", make sure the brake pipe
"a" touches the projection "b" on the brake
caliper.
REAR BRAKE
3
1
New