Configuring Online Diagnostics; Scheduling Online Diagnostics - Cisco Catalyst 2360 Software Configuration Manual

Configuring Online Diagnostics

Configuring Online Diagnostics
You must configure the failure threshold and the interval between tests before enabling diagnostic
monitoring.
This section has this information:
•
•

Scheduling Online Diagnostics

You can schedule online diagnostics to run at a designated time of day or on a daily, weekly, or monthly
basis for a switch. Use the no form of this command to remove the scheduling.
Use this global configuration command to schedule online diagnostics:
Command
diagnostic schedule test {name |
test-id | test-id-range | all | basic |
non-disruptive} {daily hh:mm |
on mm dd yyyy hh:mm | weekly
day-of-week hh:mm}
Use the no diagnostic schedule test {name | test-id | test-id-range | all | basic | non-disruptive} {daily
hh:mm | on mm dd yyyy hh:mm | weekly day-of-week hh:mm} global configuration command to remove
the scheduled tests.
This example shows how to schedule diagnostic testing for a specific day and time on the switch:
Switch(config)# diagnostic schedule test TestPortAsicCam on december 3 2006 22:25
For more examples, see the "Examples" section of the diagnostic schedule command in the command
reference for this release.
Catalyst 2360 Switch Software Configuration Guide
29-2
Scheduling Online Diagnostics, page 29-2
Configuring Health-Monitoring Diagnostics, page 29-3
Purpose
Schedule on-demand diagnostic tests for a specific day and time.
When specifying the tests to be scheduled, use these options:
• name—Name of the test that appears in the show diagnostic content command
output.
test-id—ID number of the test that appears in the show diagnostic content command
•
output.
test-id-range—ID numbers of the tests that appear in the show diagnostic content
•
command output.
all—All of the diagnostic tests.
•
basic—Basic on-demand diagnostic tests.
•
non-disruptive—Nondisruptive health-monitoring tests.
•
You can schedule the tests as follows:
Daily—Use the daily hh:mm parameter.
•
• Specific day and time—Use the on mm dd yyyy hh:mm parameter.
• Weekly—Use the weekly day-of-week hh:mm parameter.
For detailed information about this command, see the command reference for this release.
Chapter 29 Configuring Online Diagnostics
OL-19808-01