Cisco Catalyst 2360 Software Configuration Manual page 510

Working with Software Images
If the flash device has sufficient space to hold two images and you want to overwrite one of these images
Note
with the same version, you must specify the /overwrite option.
If you specify the /leave-old-sw, the existing files are not removed. If there is not enough space to install
the new image and keep the running image, the download process stops, and an error message is
displayed.
The algorithm installs the downloaded image onto the system board flash device (flash:). The image is
placed into a new directory named with the software version string, and the BOOT environment variable
is updated to point to the newly installed image.
If you kept the old image during the download process (you specified the /leave-old-sw keyword), you
can remove it by entering the delete /force /recursive filesystem:/file-url privileged EXEC command.
For filesystem, use flash: for the system board flash device. For file-url, enter the directory name of the
old software image. All the files in the directory and the directory are removed.
For the download and upload algorithms to operate properly, do not rename image names.
Caution
Uploading an Image File By Using FTP
You can upload an image from the switch to an FTP server. You can later download this image to the
same switch or to another switch of the same type.
Use the upload feature only if the web management pages associated with the embedded device manager
have been installed with the existing image.
Beginning in privileged EXEC mode, follow these steps to upload an image to an FTP server:
Command
Step 1
Step 2
Step 3 configure terminal
Step 4 ip ftp username username
Step 5
ip ftp password password
Catalyst 2360 Switch Software Configuration Guide
B-32
Chapter B Working with the Cisco IOS File System, Configuration Files, and Software Images
Purpose
Verify that the FTP server is properly configured by
referring to the
Configuration File By Using FTP" section on page
Log into the switch through the console port, the Ethernet
management port, or remotely through a Telnet session by
using the IP address of the Ethernet management port.
Enter global configuration mode.
This step is required only if you override the default remote
username or password (see Steps 4, 5, and 6).
(Optional) Change the default remote username.
(Optional) Change the default password.
"Preparing to Download or Upload a
B-13.
OL-19808-01