MicroDock II
User Manual
The gases display.
displays on the far right side of the gas that cannot be found.
The base station automatically defaults to the Purge inlet.
C
2. Press
OK to accept the default Purge inlet.
Or
Press
C
sel to select a different inlet.
C
For gases not found: If
onds, the base station automatically defaults to the Purge inlet.
3. If required, repeat steps #1-2 for any additional gases not found
and confirm the following:
•
Ensure that the selected inlet is correct.
•
Ensure that the gas cylinder attached to the selected inlet
is correct.
•
Press
C
OK to accept the base station's default selec-
tion.
58
Note
sel is not pressed within 30 sec-
Accessing the MMC/SD Card During a Test
If an attempt is made to access the MMC/SD card on the base station
from a PC while a bump test or calibration is being performed, the follow-
ing screen displays.
BW recommends that bump tests and calibrations be com-
pleted before accessing test results from the PC.
Note