Delta 36-649 Instruction Manual page 13

INSTALLING SWITCH
AND MOTOR CORD
1. Insert switch cord (A) Fig. 13, and motor cord (B)
of the switch assembly into the opening (C) under saw
table as shown, and into the inside of the saw cabinet
Fig. 14.
2. Insert switch cord (A) Fig. 14, and motor cord (B)
into clamps (D) and loosely fasten both cords (A) and (B)
Fig. 15, to the saw cabinet by turning screws (E) Fig. 14,
clockwise. NOTE: Cords will be adjusted later. Place
switch on top of the saw table at this time.
NOTE: THE MOTOR SUPPLIED WITH THIS MACHINE
HAS BEEN SPECIALLY SELECTED TO BEST SUPPLY
POWER TO YOUR MACHINE AND THE RELATIVE
SAFETY OF THE MACHINE IS ENHANCED BY ITS
USE. WE, THEREFORE, STRONGLY SUGGEST THAT
ONLY THIS MOTOR BE USED, AS THE USE OF
OTHER MOTORS MAY BE DETRIMENTAL TO THE
PERFORMANCE AND SAFETY OF THE SAW.
13
C
A
Fig. 13
B
A
D
E
Fig. 14
D
A
B
Fig. 15
B
C