Acl Re-Mark Update User Priority Configuration; Acl Re-Mark Out-Of-Profile Configuration; Acl Group Configuration - NEC N8406-023 Command Reference Manual

ACL Re-Mark Update User Priority configuration

The following table describes the Update User Priority Configuration commands.
Table 163 ACL Update User Priority Configuration commands
Command
[no] access-control list
<ACL number> re-mark in-
profile dot1p <0-7>
[no] access-control list
<ACL number> re-mark in-
profile use-tos-precedence
default access-control list
<ACL number> re-mark
show access-control list
<ACL number> re-mark

ACL Re-mark Out-of-Profile configuration

The following table describes the Re-mark Out-of-Profile Configuration commands.
Table 164 ACL Re-mark Out-of-Profile Configuration commands
Command
[no] access-control list
<ACL number> re-mark out-
profile dscp <0-63>
default access-control list
<ACL number> re-mark
show access-control list
<ACL number> re-mark

ACL Group configuration

These commands allow you to compile one or more ACLs into an ACL Group. Once you create an ACL Group, you
can assign the ACL Group to one or more ports.
The following table describes the ACL Group Configuration commands.
Table 165 ACL Group Configuration commands
Command
access-control group <ACL group
number> list <ACL number>
no access-control group <ACL group
number> list <ACL number>
show access-control group <ACL
group number>
Description
Defines 802.1p value. The value is the priority bits information in the packet
structure.
Command mode: Global configuration
Enable or disable mapping of TOS (Type of Service) priority to 802.1p priority
for In-Profile packets. When enabled, the TOS value is used to set the 802.1p
value. The default is disabled.
Command mode: Global configuration
Resets these settings to their default values.
Command mode: Global configuration
Displays the current ACL re-mark parameters.
Command mode: All
Description
Sets the DiffServ Code Point (DSCP) of Out-of-Profile packets to the selected
value. The switch sets the DSCP value on Out-of-Profile packets.
Command mode: Global configuration
Resets the update DSCP parameters for Out-of-Profile packets to their default
values.
Command mode: Global configuration
Displays the current ACL re-mark parameters.
Command mode: All
Description
Adds the selected ACL to the ACL Group.
Command mode: Global configuration
Removes the selected ACL from the ACL Group.
Command mode: Global configuration
Displays the current ACL group parameters.
Command mode: All
N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (ISCLI) 139