Layer 2 Configuration; 802.1X Configuration - NEC N8406-023 Command Reference Manual

Layer 2 configuration

The following table describes the Layer 2 Configuration commands. The following sections provide more detailed
information and commands.
Table 101 Layer 2 Configuration commands
Command
vlan <1-4095>
[no] spanning-tree
uplinkfast
spanning-tree uplinkfast
max-update-rate <10-200>
show layer2

802.1x configuration

This feature allows you to configure this switch as an IEEE 802.1x Authenticator, to provide port-based network
access control. The following table describes the 802.1x Configuration commands.
Table 102 802.1x Configuration commands
Command
dot1x enable
no dot1x enable
show dot1x
Description
Enter VLAN configuration mode.
Command mode: Global configuration
Enables or disables Fast Uplink Convergence, which provides rapid
Spanning Tree convergence to an upstream switch during failover. The
default is disabled.
Note: When enabled, this feature increases bridge priorities to 65500 for all
STGs except STG 128 and path cost by 3000 for all external STP ports.
Command mode: Global configuration
Configures the station update rate, in packets per second.
The range is 10-200. The default value is 40.
Command mode: Global configuration
Displays current Layer 2 parameters.
Command mode: All
Description
Globally enables 802.1x.
Command mode: Global configuration
Globally disables 802.1x. This is the default.
Command mode: Global configuration
Displays current 802.1x parameters.
Command mode: All
N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (ISCLI) 101