Starter Rope / Grip - Stihl FS 94 Instruction Manual

Installing
– Lubricate full length of starter
post with STIHL special lubricant,
b 12
– Fit the starter rope on the rotor,
b 7.5
1
2
: Line up the inner spring loop
(arrow) so that it locates against
the starter post (1).
: Fit the rope rotor (2) on the
starter post so that the inner
spring loop (arrow) engages the
recess (1).
The recess in the hub of the rope
rotor is the anchor point for the
spring.
1
2
: Fit the spring (1) in the rope
rotor (2) so that its loop engages
the lug (arrow).
Series 4149 Powerhead
2
: Fit the carrier (1) in position so
that the recess (arrow) engages
the spring's loop (2).
– Fit the washer and retaining ring.
– Tension the rewind spring, b 7.6
– Lubricate pegs on pawls with
STIHL multipurpose grease,
b 12
– Reassemble all other parts in the
reverse sequence.
7.5

Starter Rope / Grip

– Remove the rewind starter,
b 7.2
– Relieve tension of rewind spring,
b 7.4
The spring will not be under tension
if the starter rope is broken.
– Remove the ErgoStart / rope
rotor, b 7.4
– Remove any remaining rope from
the rope rotor.
Do not shorten the starter rope.
1
: Push the end of the starter
rope (1) out a little and undo the
knot.
– Pull the rope out of the rotor,
starter cover and grip.
Installing
: Tie special knot shown in end of
rope.
: Thread the new starter rope
through the top of the starter grip
until the knot is seated in the
recess (arrow).
1
51